User's Manual

19 / 44
Software Requirement: iOS 9.0 or later
Requirement of security software: no
Requirement of Internet: BLE
Network requirements when using the APP: The APP will not be connected to the Internet during the use of the APP, and there
is no need to connect to the Internet.
Data and Device Interface:
The data in the APP is limited to internal storage access in the APP. It neither accesses patient information data from other
systems or software nor imports patient information data into other systems or software.
The internally stored data is a patient information form and a medical treatment record form.
The APP controls the device and transmits the data from the device to the APP according to a specific encrypted instruction
protocol via Bluetooth communication.
5.2.1 Wearing the Stimulator
Wear the device at the correct location according to your need and corresponding motor response. Add some water to the area
of skin that will be in contact with the electrodes.
5.2.2 Power on
Hold the power button for 1 second and you will see following interface: The display will go to the default NMES mode in 3
seconds. Press the mode button to switch and select among NMES, ETS, PAS, EMG, GAME mode.
5.2.3 Connect with APP

Press “Mode” button to select the “GAME” mode on the stimulator.

Run SEMG-2003E APP on the iPad.
 Account registration is required for the first use.
 Enter the account number, password and confirmation password as required.
 If you forget your password, you can click to change it.
 Enter and confirm the password as required.
 Log in on the iPad.
 Click “Search” to search the Stimulator.

Choose the Stimulator and Click “Connect”.
 Enter the home interface on the iPad.