User's Manual

11 / 44
10-30mA, the intensity increases by 0.5mA increment;
>30mA, the intensity increases by 0.1mA increment;
 User can feel the stimulation each time increasing the intensity.

USB Type-C Port: The stimulator is equipped with a USB Type-C port, for device charging.

Velcro Wristband: To be worn on the arm to fix the stimulator.
3.2.2 Screen Icons
Icon
Function
Explanation
Battery
level
It will flash once per second when the battery is lower than 10%, and the
stimulator will stop and auto off in 5 minutes. The stimulator will auto off in 5
seconds when the battery is lower than 2%.
NMES
Mode
Under this mode, the stimulation will run as pre-programmed.
ETS mode
Under this mode, the stimulation will be triggered when the EMG signal reaches
the threshold.
PAS mode
The stimulation will be triggered when user contracts the muscle.
EMG mode
It displays when you choose EMG mode. The columnar and parameter represent
the EMG power, train by following the instruction,3 cycles of 3-second relax plus
6-second flex..
GAME
mode
The stimulator can connect to the APP under this mode.
Bluetooth
indicator
When you need to connect to the APP please switch to GAME mode, then you
can see the Bluetooth indicator flashes; operate the APP and stimulator by
Bluetooth and you can see the Bluetooth indicator display. Now, you can control
the stimulator by the APP.
Electrodes
loose
indicator
The electrodes loose indicator will display and the stimulator will stop when the
electrodes and the skin have poor contact. Re-adjust the electrodes and tightness
of the cuff and press Play/Pause button again to restart.
4. Setup Instruction
4.1 Use with metal electrodes
1) Peel off the transparent film from the metal electrodes.
2) Add some water to the area of skin that will be in contact with the electrodes.
3) Wear the Stimulator on the arm and make sure that the metal electrodes attach to the extensor muscles wrist extensors.
4) Press the power button to turn on the device.