Installation Instructions

6 7
1
2
3
4
4
L R
3
P1
My device
Bluetooth
Set up the
Bluetooth
L R
5
2
1
8
WARRANTY CARD
Product
name
Contact
number
Address
Date of
purchase
Username
P1
P1
3 9
FCC ID:2AYBH-MOIP1
P1
Earbuds battery capacity：35mAh
Duration : about 5.5 hours ( headset）
Charging time : about 1.5 hour ( headset）
Battery capacity : 250mAh
Charging time : about 2.5 hours
2
2
Charging of charging box: the white light is
always on during charging of charging box
When the box is fully charged: the green light
is always on
When the cover is opened or closed, the green
indicator will light up for 5 seconds
When the cover is opened or closed, the red
indicator will flash for 5 seconds
Mode 1: Put the earphone back into the charging box and close the box cover
Mode 2: When the device is not connected to the smart device, the earphone will shutdown
automatically after 5 minutes
Method 1: Open the Bluetooth list of smart devices, search for "Moi P1“ and Connection
(support for single ear use).
Pairing status: Voice prompt: "Pairing"
Connected successful: Voice prompt: "Connected"
Transparent / ANC on / ANC off: press and hold the
right ear for 3 seconds
Right ear operation in binaural mode
ANC
Pause / play: double click the headset
Last song: three hits on the left headphone
Next song: three clicks on the right headset
Left headset operation
In addition to the call status, touch the left headset for 3 seconds to
activate the voice assistant function (you need to support the connected
smart device)
Turn on / off the voice assistant: press and hold the left ear
for 3 seconds
Answer an incoming call: double click any headset
End the call: double click any headset
Rejected call: press either earphone for about 2 second
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.