Parts List/Tune Up Info

Tune Up Procedure
Tune-up procedure
PMR TEST
For BT
1: Connect to Power meter (NRVD) through RF cable and let the EUT Continuously transmit
2: Measure the Output Power Average value
Manufacturing tolerance
2.0W
Channel 5 12
Frequency
(MHz)
462.6500 462.6375
Target (dBm) 32.0 32.0
Tolerance ±(dB) 1.0 1.0
1.8W
Channel 5 12
Frequency
(MHz)
462.6500 462.6375
Target (dBm) 32.0 32.0
Tolerance ±(dB) 1.0 1.0
Bluetooth V4.2
BLE-GFSK (Average)
Channel Channel 0 Channel 19 Channel 39
Target (dBm) -3.0 -1.0 -1.0
Tolerance ±(dB) 1.0 1.0 1.0
Tune Up Procedure
1. RX Gain Calibration
a. Put DUT in test mode
b. Put DUT in BCH mode
c. Put DUT in selected channel band
d. Total gain chain calibration at center ARFCN
e. Frequency Ripple calibration
f. Complete RX_AGC Gain table
2. TX Power Calibration
a. Put DUT in test mode
b. Put DUT in BCH mode
c. Put DUT in selected channel band
d. Total gain chain calibration at center ARFCN
e .Frequency Ripple calibration
f .Complete TX_APC Gain table