Product Manual

assistant function, and that the voice assistant function has been activated in
your smart phone settings.
4. Use of remote control of the safety light
1. Specification of safety light
1) Led total brightness: 500 lumens
2) Operation mode: remote control
3) Remote control signal frequency: 433MHz
4) Mode: left turn, right turn, flash.
2. Use of remote control of the safety light
1) Press and hold the remote control of the safety light button of the smart
helmet for 3 seconds, the power of your smart helmet safety light will be turned
on, and the safety light will be on.
2) After the smart helmet safety lamp is turned on, you can operate the remote
control of the turn signal of the safety light through the matching remote control.
When you need to turn left, press the left turn button of the remote control, and
the left turn signal of the smart helmet safety lamp will flash for 8 seconds. At
the same time, you will hear the turn signal sound from the left loudspeaker of
the smart helmet sound system. The turn signal and warning tone will turn off
after 8 seconds, and the safety light will return to normal state. When you need
to make a right turn, press the right turn button of the remote control, the right
turn light of the smart helmet safety light will flash for 8 seconds, and you will
hear the turn sound from the right speaker of the audio system of the smart
helmet. The turn signal and warning tone will turn off after 8 seconds, and the
safety light will return to normal state.
3) When you need to ride at night or in complex traffic environment, you can
start the flash mode of the smart helmet safety light through the remote control
to increase your riding safety. Click the flash button of the remote control to
activate the flash function of the safety light. You can press the flash button
again to turn off the flash function.
3. Automatic induction brake
The built-in acceleration sensing chip of the safety light of the smart helmet
can sense the change of speed when you brake, and automatically highlight
the brake light of the safety light, so as to remind the rear vehicles（ Note: due
to the shaking and bumping of the vehicle during riding, the automatic sensing
braking function may be activated due to the sensitive sensing, and the bright
brake light is not a fault of the product, nor will it affect the normal use of the
smart helmet.)
4. Replace the remote controller battery
1) Please use a screwdriver or coin to turn the battery compartment cover on
the back of the remote control clockwise.
2) Remove the battery cover, remove the old button battery from the remote
controller battery compartment and install a new one.
3) Align the battery compartment cover with the notch on the back of the
remote control, press in the remote control, and use a screwdriver or coin to