User's Manual

10
4. Bluetooth Connection and
Data Syncing
⑴ The device can only be connected to the mobile app when
it is in pairing mode. Once powered on or the power switch is
pressed, the Bluetooth indicator will flash for 10 seconds
indicating the time the device remains in pairing mode.
⑵ Ensure your phone's Bluetooth is turned on.
⑶ Open the Sleeplus mobile app and ensure your phone is
close to the device. Follow the instructions on the app to bind
and connect the device. The connection is successful if the
Bluetooth indicator stops flashing but remains lit.
⑷ Once your device is successfully connected to the mobile
app, data will be automatically synced to the mobile app on
your phone. After data syncing is complete, the device will
automatically disconnect from Bluetooth and the Bluetooth
indicator will turn off.
⑸ Only iPhones with iOS 7.0 or above or Android phones
running 4.3 or above are supported. If your phone is Android
7.0 or above, please enable the Location function to connect
to the device and sync data.
11
5. Wearing Instructions
(1) Tear off the protective film on the electrodes and stick
them to the correct position on your throat, as shown below.
(2) Power on the main component and attach it to the
electrodes. Ensure that the power switch is on the inner side
nearest your throat, as shown in the image above.
(3) If you find that the anti-snoring effects are inadequate,
please try readjusting the position of the device.
⑷ It is recommended to shave any hair on the chin and
throat before use. The adhesive applying part should also be
scrubbed with soap or water to ensure it is clean and
comfortable to use.