Operating Instruction

E: Operation declaration
1：Diagrammatic sketch operation of TS14 remote control panel
2：
To code
The remote control needs to be coded with the LED lamp before use.
The method is as follows: install the LED lamp, turn the power on, light the LED lamp,
indicating that the LED lamp is working normally, press the code switch with the equipped
code needle within 8 seconds, the lamp flashes three times, indicating the success of the
code.
3：
Switch/dimming operation
After the code is successful, you can control the lamp with the remote control. Click the
remote control panel, the lamp is on, click is off again, to cycle. When you need to dimmer,
keep the finger on the remote control panel, you can adjust the light from light to light, to
achieve the appropriate brightness, let go of the finger.
4. Clear code
Select the lamp to clear the code, first cut off the receiver, and then press the remote
control code with the equipped code pin，The switch is not put, connect the receiver, the
lamp flashes six times, confirm the code clearance.
Codes switch hole