User's Manual

If pairing operations fail:
1． Delete the item from the paired list on your cell phone
Reset both the cell phone and the Bluetooth Car Kit device by powering them off and back on.
2． Re-pair the two devices
3． Turn off the cell phone and separate the battery from it for approximately five seconds .Repeat the
pairing process.
Note: In some instances, this action clears up any potential bugs built up in the cell phone software that
can hinder proper pairing.
If you have connected to your Bluetooth Car Kit to the cell phone, but do not hear anything
1． Ensure the volume control is on
2． Ensure that the earpiece is seated properly into the Bluetooth Car Kit.
3． Check the radio signal strength indicator in your mobile phone, as you may be outside the service
area.
4． Your current location may not provide good call quality. Move to a location where radio signal
strength is greater and less interference.
5． Magnetized objects such as health necklaces placed near the Bluetooth Car Kit or your mobile
phone may terminate the call. Keep away from such objects.
If the Caller ID does no show properly:
Bluetooth Car Kit supports 12 digits Caller ID. For longer phone numbers, the Caller ID will show the
latter part of the number.
Some telecom service providers do not support Caller ID, especially international calls. In this case, the
Caller ID will not show on your mobile phone.
Note: Please note that it is possible that the Bluetooth Car Kit buttons might not operate according to the
instructions this user guide if your cell phone has an unusual wireless interface. In this case, please reset
both the Bluetooth car kit and cell phone.
z Your Bluetooth Car Kit is compliant with, and adopts to the Bluetooth specification 2.0.Compatibility
between the Bluetooth Car Kit and other Bluetooth enabled devices is not guaranteed. Compatibility
depends on the devices used. For specific
Information on the compatibility between the Bluetooth Car Kit with other Bluetooth enable products,
please check with manufacturer.
FCC
Section 15.21
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment