User's Manual

6
4. Press ▲ / ▼ keys to adjust the Lo limit then press to confirm.
To skip the setting edit, press key to exit to last menu level.
The High temperature alarm range is 20-40 ℃, and the Low temperature alarm Note:
range is 0-19 ℃. The high temperature alarm default setting is 36 ℃, and the low
temperature alarm default setting is 8 ℃. When the temperature goes above or below the
settings, the temperature icon turns red. It will flash to alert user by audio beeps. Press
any key on the parent unit to stop beeping and flashing.
8.4 LULLABY SETTING
You can soothe the baby to sleep by playing a gentle lullaby from the Camera unit.
1. Press the MENU key and the menu will pop up;
2. Press the ◀ / ▶key until the lullaby icon is highlighted;
3. Press ▲ / ▼ key to select one of the 8 available lullabies, you can pick single
playback, loop (all 8 lullabies) playback or stop ;
4. Press OK key to confirm.
The lullaby default setting is OFF.Note:
8.5 ALARM SETTING
You can use the Parent Unit to set an alarm as a reminder for you to take care of your baby.
If an alarm time is selected, the Parent Unit will beep at the end of the selected hour period
from 30min to 6hrs with 30min step interval. The alarm will sound for about 1 minute
when the time is reached, or can be stopped by pressing any key.
1. Press the MENU key and the menu will pop up.
2. Press the◀ / ▶ keys until the alarm iconis highlighted.
3. Press the ▲ / ▼ keys to select the expected timers.
4. Press OK key to confirm.
The alarm default setting is OFF. When the alarm is ringing, press any key on the Note:
parent unit to stop.
8.6 DISPLAY BRIGHTNESS
1. Press the key and the menu bar will pop up.
2. Press the ◀ /▶ keys until is highlighted.
3. Press the ▲ / ▼ keys to select the desired brightness level from level 1 ~ 5.
(The default brightness level setting is level 3.)
8.7 VOX SETTING
This mode allows you to control the sound activation of your baby unit. If there is no sound
around the baby unit within 30 seconds, it will stop audio transmission and turn off the
screen of the parent unit. When the baby unit detects any sounds louder than the sensitivity
level, it will start transmitting the signal to the parent unit again and turn on the screen of the
parent unit. To change the VOX level, please follow the below instructions.
1. Press key and the menu bar will pop up.
2. Press◀ /▶ key until is highlighted
3. Press ▲ / ▼ key to select the VOX sensitivity level.
4. Press key to confirm setting.
VO X