User's Manual
Table Of Contents
- 1.The Basics
- 2.Introduction
- 5.Trouble Shooting
- 6.Accessories
- 7.Specifications
- 8.Electromagnetic Compatibility
- FCC Warnning:
- This device complies with part 15 of the FCC Rules
- (1) This device may not cause harmful interference
- (2) this device must accept any interference recei
- Note: This equipment has been tested and found to
- -Reorient or relocate the receiving antenna.
- -Increase the separation between the equipment and
- -Connect the equipment into an outlet on a circuit
- -Consult the dealer or an experienced radio/TV tec
- The device has been evaluated to meet general RF e
8
3. Using the thermometer
3.1 Charge the Battery
1. The device has a built-in lithium battery, which can be c
harged for repeated use;
2. The user connects one end of the USB cable to the powe
r adapter, and inserts the other end into the host USB chargi
ng interface for charging. After the power is connected, char
ging animation will be displayed;
3. After charging, rest the screen and shut down;
Note 1: Bluetooth is turned on when charging, and the host
is in the power-on state. However, temperature and pulse r
ate measurement are not supported when charging.
Note 2: The device cannot be used during charging.When ch
arging, you must use a class Ⅱ adapter conforming to IEC/
EN 60601-1, and the output is DC 5V 1A. If it is not follo
wed, there may be a risk of electric shock.
3.2 Before Measurement
1. Clean and disinfect the thermometer before use, and take a
proper rest before measurement. If you feel unwell, you should
consult your doctor immediately in addition to the measurement
results of this device.
2. Please press the temperature/pulse button to start the product.
3. After starting up, the record is displayed on the screen,
indicating that the value is the recent measured historical data.
When the power is less than 3%, the display screen will prompt
when starting up, and it will automatically shut down after 2