User's Manual
Table Of Contents
- 1.The Basics
- 2.Introduction
- 5.Trouble Shooting
- 6.Accessories
- 7.Specifications
- 8.Electromagnetic Compatibility
- FCC Warnning:
- This device complies with part 15 of the FCC Rules
- (1) This device may not cause harmful interference
- (2) this device must accept any interference recei
- Note: This equipment has been tested and found to
- -Reorient or relocate the receiving antenna.
- -Increase the separation between the equipment and
- -Connect the equipment into an outlet on a circuit
- -Consult the dealer or an experienced radio/TV tec
- The device has been evaluated to meet general RF e
7
1. Temperature Key
Short press the power on, and drip a sound, long press 3 seconds
off;
Press to start/stop temperature measurement.
2. Pulse rate Key
Short press the power on, and drip a sound, long press 3 seconds
off;
Press to start/stop pulse rate measurement.
3. Display Screen
It can visually display the temperature or pulse measurement
results.
4. Probe Tip (Temperature sensor)
By touching it, the temperature can be measured.
5. Pulse sensor
Pulse rate can be measured by touching it.
Note: Type DT-10 and DT-10B have no pulse rate function.