User's Manual
Table Of Contents
- 1.The Basics
- 2.Introduction
- 5.Trouble Shooting
- 6.Accessories
- 7.Specifications
- 8.Electromagnetic Compatibility
- FCC Warnning:
- This device complies with part 15 of the FCC Rules
- (1) This device may not cause harmful interference
- (2) this device must accept any interference recei
- Note: This equipment has been tested and found to
- -Reorient or relocate the receiving antenna.
- -Increase the separation between the equipment and
- -Connect the equipment into an outlet on a circuit
- -Consult the dealer or an experienced radio/TV tec
- The device has been evaluated to meet general RF e
10
3.4 After Measurement
1. When the buzzer emits a beep sound(Beep-short sound) , it
indicates that the temperature measurement is finished. The
display "°C/℉" stops blinking, and the displayed temperature
value is the result of the current body temperature.
2.Turn off the thermometer: press and hold (> 0.5 seconds) to
switch the thermometer off.
3.If no operation is performed for more than 3 minutes, the
thermometer will automatically turn off. It is recommended to
manually turn off the thermometer after the temperature
measurement to extend the battery life.
3.5 Pulse measurement
1. Place your finger on the pulse sensor and gently touch the
pulse sensor for 30 seconds.
2. After the finger continues to contact the pulse rate probe for 10
seconds or more, the finger leaves the pulse rate probe to display
the average pulse rate. At this time, the measurement results do
not flicker, but emit drip-drip sound to save the data.
3. The measurement will automatically end after 1 minute. At this
time, the measurement results will not flicker, but emit three
beeps to save the data.
Note 1: Do not press the device too tightly against the skin as this
may cause measurement errors.
Note 2: The pulse rate measurement range is 40Bpm-200Bpm.
When the measured value is not within this range, the heart icon
will flash and the pulse rate will be displayed. There is no