User's Manual

- 深圳云视科技开发有限公司
产品规格书
6
5.7 Label and compliance information
This Label contains: The product name :
Model： UM-MR133
FCC ID： 2AZ2R-UMMR133
FCC regulatory information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Warning: changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
End Device Labelling
Please notice that if the FCC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also
display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains FCC ID: Z4T-WM1302-A and Z4T-WM1302-B” any similar wording that expresses
the same meaning may be used.
RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20cm between the radiator
& your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Installation Notice
The module is limited to OEM installation ONLY. The OEM integrator is responsible for ensuring that
the end-user has no manual instruction to remove or install module.
The module is limited to installation in mobile application; A separate approval is required for
all other operating configurations, including portable configurations with respect to Part 2.1093
and difference antenna configurations.
FCC Part 15B Compliance of End Device
The OEM integrator is responsible for ensuring that the host product which is installed and operating
with the module is in compliant with Part 15B unintentional Radiator requirements, please note that
For a Class B digital device or peripheral, the instructions furnished the user manual of the end-user
product shall include the following or similar statement, placed in a prominent location in the
text of the manual: Note: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.