User's Manual

etc.
6. 2. Failure caused by the use environment not meeting the
product requirements.
7. 3. Failure or damage caused by force majeure (such as fire,
earthquake, lightning, etc.).
8. Damage caused by use, maintenance, and maintenance not
in accordance with the requirements in the product manual。
9. Damage to the product shell, power supply, etc. caused
during use.
10. The warranty card is inconsistent with the product serial
number or the warranty card has been altered.
All products that are not covered by the free warranty and
can be repaired are provided with paid repair services.
The final interpretation of the content of this warranty card
belongs to our company.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful
interference in a
residential installation. This equipment generates uses and
can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help
Changes or modifications not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment shall be installed and operated with
minimum distance 10cm between the radiator & body.