User's Manual

ManualsBrandsShenzhen Tyroq Smart Technology ManualsAudio EquipmentTWS earbuds

Table Of Contents

1 / 6

User Manual

●Dual-ear mode: Initial use of headsets

1. Take out both left and right earphones from the charging box when using it for the first time. Tear off the film. Put both

earphones back into the charging box. close the charging box, and then open the charging box.The two earphone indicator

lights is on. The headset is activated.

apparel

Please follow the diagram to penetrate the earphone into the ear, press the R<> right ear and LRR<> ear correspondence.

Please rotate the headset slightly and adjust to a comfortable angle to ensure that the headset is stable and tight to prevent

the headset from falling off.

Summary of content (6 pages)

PAGE 1
User Manual ●Dual-ear mode: Initial use of headsets 1. Take out both left and right earphones from the charging box when using it for the first time. Tear off the film. Put both earphones back into the charging box. close the charging box, and then open the charging box.The two earphone indicator lights is on. The headset is activated. apparel Please follow the diagram to penetrate the earphone into the ear, press the R<> right ear and LRR<> ear correspondence.
PAGE 2
Basic Operations ○Automatic power on/off: Open the lid of the charging box, the headset will automatically turn on and the TWS connection is successful. The headsets automatically shut down after 3 minutes of pairing timeout. Put the earphone back into the charging box and close the charging cover. The earphone will automatically shut down after disconnecting the phone and enter the charging state.
PAGE 3
Cancel outgoing call: When the call is made, double-tap the left earphone (L) or right earphone (R) to cancel the outgoing call. ○Music play/pause: When the music is being played, you can double-tap the left earphone (L) or right earphone (R) to pause the music, or repeat the same action to start playing the music again. ○Previous Track: Long touch the left earphone (L) for 3 seconds. ○ Next Track: Long touch the right earphone (R) for 3 seconds.
PAGE 4
Charger and Battery Before using any charger to charge this earphone, check whether the specifications of the charger meet requirements. The recommended output voltage of the charger is DC5V+/-0.25V, and the recommended output current is 100 mA to 500 mA. An over-high charging voltage may damage the earphone. Warning: Use the recommended charger whenever possible. Use of other types of chargers may violate the warranty terms of the equipment and results in danger.
PAGE 5
in a cool and well-ventilated place, and charge the earphone once every two months. When the white LED light of the connected headset flashes with a "beep" tone, it indicates that the headset is low on power. If you continue to use it, it will automatically shut down. At this time, you need to put the headset back into the charging box to charge.
PAGE 6
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.