User's Guide

The cleaning method can be viewed by clicking the [Clean the clogged nozzle] on the

maintenance screen. Please operate following the instructions on the screen.

6.2.2 Clogged Nozzle Cleaning

6.3 Platform Replacement

< Maintain

Method 1: Preheat the extruder, and heat the extruder to the required temperature

of the material used. Pull out the ﬁlament guide tube, press the handle, pull out the

ﬁlament, and insert the unclogging pin tool into the nozzle for unclogging.

Clean the clogged nozzle

1/2

The replacement method can be viewed by clicking the [How to Install a Glass

Platform?] on the maintenance screen. Please operate following the instructions

on the screen.

6.3.1 Glass Platform Replacement

Note: After the glass platform and flexible steel plate platform are exchanged,

the extruder height must be calibrated.

Note: The screws may become stripped after long-term use. If so, the spare screw

holes on both sides can be used.

< Maintain

After the ﬂexible steel plate is removed,

press the rear edge of the glass against

the positioning block, lay it ﬂat on the

build platform, install the hand screw bolt

to the front end of the platform, and then

rotate the hand screw bolt clockwise to

clamp the glass platform.

How to Install a Glass Platform？

1/3