User's Guide

Load Unload Clean
< Load
< Load
Custom
Custom
Please set the extruder temperature(℃):
OK
During filament loading and unloading, users can select the corresponding filament
to be installed on the screen. If the currently used filament is not listed on the screen,
users can customize the filament and set the required temperature for filament loading.
When the filaments printed in the last two times are different, please carry out filament
cleaning. In this way, it will avoid the situation that the carbonized filament leads to
nozzle clogging or there is no filament extrusion due to different melting temperatures
of different filaments. When switching from a filament of high printing temperature to
a filament of low printing temperature, this operation must be performed; For example,
when you need to switch to PLA filament after printing with PC filament, it is necessary to
clean and remove the PC filament from the nozzle, so it is necessary to set the
temperature required for melting PC filament until all the PC filament is extruded from
the nozzle and there is no residue left in the nozzle.
The filament screen includes:
[Load], [Unload] and [Clean].
5.2 Filament Screen
200
Filament cleaning
16
PLA
1/2
ABS
PETG
PC PA66
PA12