User's Guide

1. Please remove the camera cover before using the camera;

2. Turn on the camera switch;

3. After the equipment is connected to FlashPrint, the real-time videos and images can

be viewed in the FlashPrint - [Multi-Machine Control].

1. If the flexible steel plate platform is used, after printing is completed, directly lift the

handle to remove the flexible steel plate and bend the platform plate to remove the

model;

2. If the glass platform is used, after printing is completed, directly remove the model

with a scraper.

When using the flexible steel plate platform,

remove the model and put the platform plate

back into the equipment. Operate as follows:

1. Hold the rear end of the flexible

steel plate against the positioning

blocks on the left and right edges of the

platform (note that it is inserted into the

inside of the positioning blocks);

2. The platform will be automatically adsorbed

and installed on the platform.

4.4 Camera Connection

When removing the model from the build plate, please pay attention

to the need to wait for the platform to cool down before operating.

At this time, you can check the temperature icon on the status bar of

the screen to confirm the platform temperature. The green icon

indicates that the platform temperature is lower than 50℃, which is

the appropriate state for safe operation. The matching gloves can be

used when removing the model. In the meanwhile, pay careful

attention to the high temperature of the equipment.

4.5 Model Removal After Finishing Printing

WARNING

Glass PlatformFlexible Steel Plate Platform