Product Specs

FCC ID: 2AYHW-TL7100C

conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

FCC Caution:

Any changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate this equipment.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance 20cm

between the radiator & your body.

FCC INFORMATION (additional)

OEM INTEGRATION INSTRUCTIONS:

This device is intended only for OEM integrators under the following conditions: The module must

be installed in the host equipment such that 20 cm is maintained between the antenna and users,

and the transmitter module may not be co-located with any other transmitter or antenna. The

module shall be only used with the internal antenna(s) that has been originally tested and certified

with this module. As long as 3 conditions above are met, further transmitter test will not be

required. However, the OEM integrator is still responsible for testing their end-product for any

additional compliance requirements required with this module installed (for example, digital

device emissions, PC peripheral requirements, etc.).

Validity of using the module certification:

In the event that these conditions cannot be met (for example certain laptop configurations or

co-location with another transmitter), then the FCC authorization for this module in combination

with the host equipment is no longer considered valid and the FCC ID of the module cannot be

used on the final product. In these circumstances, the OEM integrator will be responsible for

re-evaluating the end product (including the transmitter) and obtaining a separate FCC

authorization.

Module label:

The final end product must be labeled in a visible area with the following: “Contains FCC

ID:2AYHW-TL7100C ”. Information that must be placed in the end user manual:

The OEM integrator has to be aware not to provide information to the end user regarding how to

install or remove this RF module in the user's manual of the end product which integrates this

module. The end user manual shall include all required regulatory information/warning as show in

this manual.

The module not applicable Limited module procedures. The module is a Single module and

complies with the requirement of FCC Part15.247

The module has its own antenna ，and doesn't need a host's printed board microstriptrace

antenna etc, Not applicable Trace antenna designs