Operation Guide

-
12
-
Receive Collar
NOTE: CHARGE RECEIVER BEFORE FIRST USE. IF
IT DOESN’T CHARGE CONTACT US IMMEDIATELY
On/Off Button
Press and hold on 4 seconds to turn the collar on. Two confirming tones will sound and
the collar green LED light will flash 1 time per 5 seconds if connected. The LED will
flash fast if disconnected. Press and hold on 4 seconds to turn the collar off. One long tone
will sound and the green LED light will stop flashing and turn off.
Turn the collar off when not in use to conserve battery
Turn on the anti bark function.
Press and hold on 2 seconds when receive collar is on , the Red LED light on then release
at once .The anti bark function is on, the remote function is off. The green LED will flash
2 times of 5 seconds. Press and hold on 2 seconds again, the Red LED light on then
release at once .The anti bark function is of f, the remote function is on . The green LED
will flash 1 time of 5 seconds.
Contact Prong
Choose short or long prong to match
the dog’s coat type.
LED Light
Indicate the working
status, low
battery ,charging
status.
DC Jack Cover
Open the Rubber Cover
and insert the adaptor
plug into DC Jack to
charge.
Microphone
Dog bark sensor, Pick up
the dog’s bark
High Light LED
For the 1
st
dog , the
high light LED is
White; For the 2
nd
dog ,the high light
LED is Red ;For
the 3
rd
dog ,the
high light LED is
Green