Operation Guide

- 24 -
have individual sensitivity levels. Also, different types of training
call for different levels of intensity. So it’s wise to test your dog to
find the correct intensity level before you start training.
IMPORTANT: For best results when finding your dog’s sensitivity,
use continuous stimulation. If your transmitter has more than one
button for continuous stimulation, use the button for the lowest
level when finding your dog’s sensitivity.
NOTE: If your dog overreacts (vocalizes or acts “rattled”) when
you use the lowest level of continuous stimulation that’s available
on your collar model, then retest for sensitivity starting with the
lowest level of momentary stimulation. If your dog doesn’t respond
up to level 40, check to see if the receiver is snug against your dogs
neck and start again from level 1. If you still have no luck in getting
a response, you have two options: trim the hair beneath the receiver
or switch to the longer prongs. After all these steps if you are still
having problems email us.
Test Light Instructions
1. Turn the collar receiver on.
2. Insert the contact points into the Test Light.
3. Press a stimulation button on the remote transmitter.