Operation Guide

- 15 -
display occurs then release, the transmitter is now on.
If you want to match the 1
st
dog , please choose first
dog ,The LED display “1”
If you want to match the 2
nd
dog , please choose the second
dog , the LED display “2”
Step 3: Press and hold the Vibration buttonand Highlight Led
button at the same time .until TheLED display
is“P”.Not to release the two buttons.
Step 4: Hold the transmitter close to the unmatched receiver 1 to
2inches away.After hearing 5 “beeps” sound from the
receiver and you see the green LED flashing slow down to
once every 4-5 seconds, you release the button. It should
connect pretty fast.
Step 5: Test matched Receiver
press Beep button, if you can hear the “beep” sound from
the matched receiver then congratulations, you have
matched the receiver. You can also use the test light to
place the prongs in the little gaps and press each button on