Operation Guide

- 14 -
stopper in place. This does not affect performance.
7.You may use any collar with the receiver as long as it
fits correctly.
Setting Up Multi-Dog System
1. Match a Receiver CollarTo add a receiver collar to your remote
dog training system, following the below steps. Only turn on 1
collar at a time to connect.
Step 1: Take out 1 unmatched receiver collar. Press and hold
“ON/OFF” button. After two “beep” sounds, release the
button, the receiver power is on. Green LED light should be
flashing frequently. This means the collar is disconnected
from the remote.
(Note: Never open 2 or more unmatched receivers at the same
time.)
Step 2: Take out the transmitter that you want to match to the
receiver. Press and hold on the “ ” button until LED