Operation Guide

- 26 -
IMPORTANT: If you are experiencing any
issues with collars beeping or vibrating
randomly when they are not near the wire
perimeter, this may be an interference
issue caused by your perimeter setup and
you need to add a resistor unit as per
instructions below to rectify the situation:-
 Make certain you are using Min 80m/262
Feet of wire in you Perimeter Boundary.
 If you have small perimeter, this may cause
inference and cause collars to beep/vibrate
randomly within the perimeter. In that case,
connect the resistor unit found in your pack
to one end of the Wire Connection Terminal
and the cable to other end of the resistor as
per the picture below.