Quick Guide

PASSWORD: The default setting is OFF. Press the ▼ button to highlight the Password
option in blue. Press OK. Scroll ▲ (up) to ON and press OK. Use the ▲ and ▼ buttons
to choose your password and press OK to save your personalized password. Make sure
you write down your password or store it in your phone so you don’t lose it. If you set
this option to ON, you will not be able to access your camera without the password. This is
a very important security feature. If you forget your password, please email us at
[e-mail] or call us at 877-462-1799 to request RA #.
RENAME: The default setting is OFF. Press the ▼ button to highlight the Rename option
in blue. Press OK. Use the ▲ and ▼ buttons to choose your rename and press OK to
save. Note: You can only use numbers 0-9 and letters A-Z.
OVER WRITE: The Over Write function will save new photos over the old photos on your
SD card if it becomes full. Each time a new photo is taken the oldest photo on the card will
be overwritten. Press the ▼ button to highlight the Rename option in blue. Press OK.
Use the ▲ and ▼ buttons to choose your rename and press OK to save. If you want to
change this, Press the ▲ button to highlight the YES and the ▼ button to highlight NO.
Press OK to save your preferred setting.
FORMAT: Formatting your SD card clears everything off the card. (It will delete any
pictures that are stored on the card!) We recommend formatting your SD card every time
before using your camera. Even if you have a new SD card, you should always format the
card before you use it in the camera. To format the SD card, press OK and then scroll ▼
(down) until YES is highlighted in blue. Press the OK button. You will see a screen that
has “Please Wait” pop up. When the camera goes back to the previous screen, your SD
card has been formatted.
DEFAULT: The Default option resets all the settings to the original factory default settings.
Press the OK button. Use the ▼ button to highlight the YES option. Press OK. When
your camera goes back to the previous screen, it was defaulted to the manufacturer’s
settings.
SOFTWARE VERSION: This is for manufacturer/engineering purposes only.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio