Quick Guide

Press the ▼ button to highlight the Trigger Mode option in blue. Under this setting you
can choose PIR Trigger (Where the camera is triggered by heat or motion only), Time Lapse
(Where you tell your camera to take pictures every 5 seconds up to 24 hours) or Both.
Highlight your selection and press OK. Press the Menu button to go back to the previous
screen.
If you chose PIR, you will see PIR Sensitivity where you can choose low, normal or high
settings. PIR Interval is the next customizable setting. This is the amount of delay
between each picture. For example, if you have the PIR Interval set to 10 seconds, the
camera will wait 10 seconds before it allows itself to be triggered again by heat or motion.
Press OK to save.
If you chose PIR + Time Lapse, you will see PIR Sensitivity where you can choose low,
normal or high settings. PIR Interval is the next customizable setting. This is the amount
of delay between each picture. For example, if you have the PIR Interval set to 10 seconds,
the camera will wait 10 seconds before it allows itself to be triggered again by heat or
motion. Directly below is Time Lapse as the second option. Press OK and then you can
see where you can make your selection on how often you want your camera to take a picture,
regardless of whether it is triggered by heat or motion. Be sure to press OK to save your
settings.
If you chose Time Lapse only, then you will see Time Lapse as the second option. Press OK
and then you can see where you can make your selection on how often you want your
camera to take a picture, regardless of whether it is triggered by heat or motion. Example:
If you set your camera on a 5 second time lapse, your camera will take a picture every 5
seconds or 12 pictures every minute. Be sure to press OK to save your settings.
Work-Time Menu: (WKT)
If you only want your camera to be on during part of the day each day you can set the Work
Time function(s). Press the ▼ button to highlight the Work Time 1 option. The default
setting is OFF. Press the ▲ button to toggle the setting to ON and press OK.