User's Manual

3 in 1 Wireless Charging Stand
Model NO.: WCS08
LED Power Indicator
iWatch Wireless Charging Stand
Type C USB Port
Non-slip Silicone Pad
Thanks for choosing our Wireless Charging Stand!
This is a smartphone wireless charging Stand for
iPhone 11Pro，iPhone 11，iPhone XS, iPhone XR Max,
iPhone X, iPhone 8, iPhone 8 Plus,
Samsung Galaxy S9,S9+,S8, S8+, Qi-enabled devices
and other digital devices.
Please kindly read the user manual before using.
How to use
Connect to power Adapter
Connect to laptop for charging
charging mode
Install iWatch charging cable
First put the iWatch charging cable into the silicone sleeve
and fix it on the bracket, then pull down from the groove on
the back of the bracket, pass through the base, and finally
fix the wire.
Note: Suitable for putting 1m iWatch charging cable
Product Specifications
Connect the power adapter to socket.
Connect adapter to the USB 2.0 interface, the other
TYPE-C USB to the Wireless Stand.
Connect the USB 2.0 interface into laptop USB port, the other
TYPE-C USB to the Wireless Stand.
Standby LED light turn on red.
LED indicator
1. Turn on: LED Red->Green->Red->Light off
2. Stand by: LED Light off
3. Charging: Green LED keep lightning on
4. FOD: Red LED blink
Standard: QI wireless charging standard
Input: DC5.0V --- 3A , DC9.0V --- 2A
Output 1: 5W for iWatch
Output 2: 5Wfor AirPods
Output 3: 5W, 7.5W, 10W max
Transmission Distance: <8mm
Conversion Efficiency: ≥72%
Products Supplied
Wireless Charging Stand
User Manual
EU Compliance Operation Frequency Band/Max. RF power
transmitted: 115kHz to 205kHz, 104.76dBμV/m at 3m distance.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:(1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment
should be installed and operated with minimum distance between 20cm the
radiator your body: Use only the supplied antenna.