User's Manual

SECURITY FEATURES
back off, the system will unlock the doors to allow an easy exit from the
vehicle. If desired, either one or both of these features can be turned off by
your installer.
6 7
SECURITY FEATURES
PROGRAMMING
1. Turn ignition ON.
2. Toggle valet switch 3 times ON/OFF. Siren will chirp 2 times.
3. Press BUTTON 1.
4. Siren will chirp 2 times.
5. Toggle valet switch OFF
6. Turn ignition OFF
OTHER USEFUL INFORMATION
LOW VEHICLE BATTERY?
Should you ever experience a situation where:
• The starter will not engage after the alarm has been disarmed.
• The starter engages and then almost immediately disengages.
These conditions are almost always caused by a week or defective vehicle
battery. “ IF “ this happen, TOGGLE THE VALET SWITCH ON WHILE
TURNING THE IGNITION KEY TO THE START POSITION. This will bypass
the starter interrupt in the system control module. Should this situation
continue to occur, have your vehicle battery and starting system checked out
by your mechanic.
SYSTEM MAINTENANCE
Your security does not require any specific maintenance except for
occasionally changing transmitter batteries. However, it is suggested that
the system be armed and all protected zones should be checked on
OTHER USEFUL INFORMATION
regular basis to make sure that they trigger an alarm cycle. Should the
system malfunction in any way, contact your dealer as soon as possible
for service.
ABOUT TRANSMITTER RANGE….
The receiver inside your vehicle security system and the remote control
transmitter are designed together to have an effective operating range of
up to 50 feet during normal conditions. Although at times you will
experience range greater than that, there are certain conditions that will
cause the effective transmitter range to be less than you would normally
experience. Atmospheric conditions and radio interference are just a few
example of the types of interference that can reduce transmitter range.
This device complies with FCC rules part 15. Operation is subject to the
following two conditions: (1) this device may cause harmful interference
and (2) this device must accept any interference that may cause
undesired operation. Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.