User's Manual

ManualsBrandsSHENZHEN TOKWA PRECISION TECHNOLOGY ManualsCD-playersCAR CD RADIO PLAYER WITH BT

Placing the device in operation

Attaching the control panel

Push the control panel into the bracket at the

right edge of the device.

Push the control panel carefully into the left

bracket until it clicks into place.

Removing the control panel

Press the

button

to unlock the control

panel.

The left side of the control panel detaches

from the device and is secured by the bracket

against falling out.

Move the control panel slightly to the left

until it disengages from the right bracket.

Carefully remove the control panel from the

left bracket.

Note:

The car sound system automatically switches

o as soon as the control panel is removed.

Display language

(only Toronto 410 BT)

For the Toronto 410 BT, you can de ne whether

the language for messages on the display is Eng-

lish or German. The setting is performed in the

user menu (see the chapter "User settings", section

"Making settings in the "DISPLAY" menu", menu

item "LANGUAGE" ).

Setting the reception area

This car sound system is designed for opera-

tion in di erent regions with di erent frequency

ranges and station technologies. The factory de-

fault of the reception area is "EUROPE". In addi-

tion, the reception areas "USA", "THAILAND" and

"SOUTH AMERICA" are available.

Note:

If you operate the car sound system outside

of Europe, you may  rst have to set a suit-

able reception area in the user menu (see

the chapter "User settings", section "Making

settings in the "TUNER" menu", menu item

"TUNER AREA").

쏅

Switching on/o

Switching on/o with the On/O button

For switch-on, press the On/O button

The car sound system switches on.

To switch o the device, press and hold down

the On/O button

for longer than 2 sec-

onds.

The car sound system switches o .

Note:

If you switch on the car sound system while

the vehicle ignition is switched o , it auto-

matically switches o after 1 hour to preserve

the vehicle battery.

Switching on/o via vehicle ignition

The car sound system will switch o /on simulta-

neously with the ignition if the device is correctly

connected to the vehicle’s ignition as shown in the

installation instructions and you did not switch the

device o by pressing the On/O button

Volume

Adjusting the volume

You can adjust the volume in steps from 0 (o ) to

50 (maximum).

Turn the volume control

to change the

volume.

Note:

If a telephone or navigation system is con-

nected with the car sound system as de-

scribed in the installation instructions, the car

sound system is muted in case of a telephone

call or navigation announcement so that

you can hear the playback of the telephone

or navigation system undisturbed. While it is

muted, the display shows "TELEPHONE".

Muting the car sound system (Mute)

Brie y press the On/O button

to mute

the car sound system or to reactivate the pre-

vious volume.

While it is switched low, the display shows

"MUTE".

쏅

02_MadSanTor_gb.indd 28

11.11.2010 11:12:02 Uhr