User's Manual

T6
Wireless Charger Stand
This is a multi-functional phone stand with wireless
charging, simple design as safe and portable, support Qi
standard, compatible with all wireless charging phones
which meet Qi standard, this product will give you a safe
and convenient using environment.
phone charging area
anti-slide silica gel
1. Place this stand on desktop, connect with USB cable,
now it is standby mode: indication light 1 is on green,
indication light 2 is on green
extending pipe
extending pipe
type-c port
2. Put the wireless charging phones on the wireless charging
stand, now it is charging mode: indication light 1 is on blue,
indication light 2 is on blue
extending feet
3. When it is not in normal working status( something else on
it is detected or functional error):
the indicator light flashes red and blue,
4. The extending feet is free in adjust according to different
phone size, the extending pipe is also adjustable for height
when in real usage, but it can be also folded when need to
take along.。
User Manual
indication light 1
indication light 2
after folding
Product introduction
Operation guide
Basic Parameters:
Notice:
Packing list:
Wireless charging phone stand x1
USB cable x1
User manual x1
Compatible devices:
HUAWEI：P30 pro, Mate 20 pro,Mate 30,mate 40 ,P40pro
IPHONE：iPhone 8,iPhone 8 Plus,iPhone X,iPhone XR,
iPhone 12,iPhone 12 pro max
SANSUNG：Note9,S9,S9+,Note8,S8,S8+,S7Edge,S7,Note5,
Note6,Note7,S6Edge,S6Edge+,SM-W2019,
SM-W2018,SM-W2017
NOKIAlumia：930，830，1520，1020，820，720，920，925
GOOGLE Nexus：4/5/6/7
XIAOMI：MIX2S ，10/10pro ，9/9pro,MIX3
Note: compatible all devices support Qi standard
( above are only part of them).
Input:：9V/2A
Output: 10W /7.5W /5W
Charing distance: ≤8mm
Charging efficiency: ≥76％
3-in-1 wireless charging station
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter. During the operation of device a
distance of 15 cm surrounding the device and 20 cm above the top surface of the
device must be respected.
FCC StatementFCC Statement