User's Manual

Water inlet

rubber plug

instructions

Water tank filling

Battery

Power on / off

Open the flap to take out the water tank and open the

rubber plug and put the water into the tank, then plug

the rubber plug tightly when the tank is full. Put it

back to the device, and close the flap.

The power switch is on the right side of the bottom.

(as shown in the figure above)

Press "1" for power on, press "0" for power off. After

power on, the device needs about 10 seconds for self

checking. After self checking, the device starts normally.

(1) Please check whether the water tank needs to be

added water or the sewage tank needs to be dumped

before starting the device.

(2) One of the five working modes, which are automatic,

sweeping, wet mopping, fixed point sweeping, and fixed

point wet mopping, can be selected as the current

working mode.

Note: this device has the function of setting up map

and planning path, which can automatically return the

charging station.

The device uses a high-performance lithium-ion

rechargeable battery pack. In order to maintain

the battery performance, please keep the device

charged for daily use.

Note: if not used for more than 24 hours, please

turn off the power switch of the device.