Operation Manual

TeamGee Electric Skateboard
10
Instruction for Remote Control Code
•
Under normal circumstances, the code program of each board and the supporting remote control has
completed when the product leaves the factory, so consumers do not need to code again. However,
when you accidentally lose the remote control or buy a new remote control or the remote control is
damaged and repaired, the code must be completed before use.
•
Steps:1
1 .First turn on the power of the board.
2. Long press the power button of the board for about 5-8 seconds and release the button after the
power indicator of the skateboard starts to flash.
3.
Turn on the power of the remote control.
4. Use a toothpick or a paper clip to click on the remote control’s code key. At this time , the power
indicators of the board and the remote control shall flash at the same frequency.
5.
Restart the key to turn on the skateboard and the remote control,and then it can be operated
normally.
•
Steps:2
1. After starting the scooter, long press the power switch for 10 seconds (or short press the motherboard code button once) and
then enter the state of main board code
2. Turn on the power of the remote control and simultaneously press and hold the "Speed switch button" and the "Settings
button" to complete the process of code matching
3. After the completion of the coding process, the remote control will restart and the remote control will display the power of
the scooter, and the power indicator of the scooter will flash
4. If the above state does not occur, the code matching process shall be completed again (sometimes the remote
control shall be switched on and off again).