User Guide

Macros can be set with PS4 and PC. You can store up to 2 macros.
The ML/MR buttons can be set to 1-12 button presses respectively .
These 14 buttons can be set with macros:
Triangle, square, circle, cross, L1, L2, R1, R2, L3, R3, up, down, left, right.
The option button will set a sequence of button presses, for example first L1 then L2.
The share button will set a simultaneous press of buttons, for example L1 and L2 at the same
time .
Press and hold either the share or option button and one of ML or MR buttons for 2-5 seconds. If
the game controller is connected with Bluetooth the LED will change to yellow.
Press the button sequence/macro that you want to set. Then press ML or MR buttons to save.
The LED changes color to confirm .Press ML or MR to activate the macro.
To reset a macro, press and hold either the share or option button and one of ML or MR buttons
for 2-5 seconds. The LED changes to yellow ( Bluetooth only). Press ML or MR again. The macro is
now reset. You can also press the off button to reset a macro.
If you are connected with cable the LEDS will not respond, but the macro will still be set and
saved .
FCC Caution：
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.