User's Manual

After you have successfully connected with an Apple devices like iPhone or iPad, you will
see a small battery icon indicating the battery level of your headset so you are always ready
to party. (only applicable for selected Apple devices)
Battery charging and low-voltage alert
When connected normally to charge, the red LED is on when charging and LED turn off
when charging is complete. This takes 2-3 hours.
When the battery is running low,the red LED will flash twice every fifteen seconds.Charge as
soon as possible or it will automatically shut down.
Remarks
1) If headset stand by with paring mode for 5 min and without connection, It will be exit
paring mode automatically, also, the device will power off after another 5 min.
2) Automatic re-connection can happen in the two cases:
a. When headset is turned on, it will connect to the pre-set device automatically.
b. When headset disconnects from the device due to an exceeded effective range (normally
< 10 meters), it will re-connect to your device if it is back in the effective range within 5
minutes.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and