User's Manual

ManualsBrandsShenzhen Sunricher Technology ManualsElectronicsRF sender

Table Of Contents

RF wireless RGB remote controller

Feature

Parameter

Description of buttons

Remote

Part No.

Operation Voltage

Operation

Frequency

SR-2839W 4.5VDC

916.67MHz

Remarks

RF Wireless

Wiring diagram

1 zone/area

Press-button RGBW controller

Built-in 10 modes

Product Size

Receiver

Part No.

Input Voltage

Remarks

Output Current

SR-1029RGBW 12-24VDC

Constant voltage

4x(60-120)W

4x5A

Output Power

ON/OFF For Warm white, Natural white,

Cool white changing.(Through the

three RGB color mixing)

Indicator Color wheel

Brightness Play&pause button. There is 10 build-in

modes. Short press it will play, short

press again, it will pause. Long press

it will speed up/down..

Change red channel Change green channel

Change blue channel

Change white channel

Save color/scene

Power Supply

12-24VDC

110V-230VAC

R-

G-

B-

17.6

120.0

47.9

SR-2839W

S2S1

RF Co de Key

RGBW LED Controller

V+

V-

INPUT

V+

R-

G-

B-

OUTPU T

Input Vo ltage D C 12-24 V

Outpu t Curre nt 5A/C H

Max Pow er 60-1 20W/C H

W-

R-

G-

B-

RF Co de Key

RGBW LED Controller

V+

V-

INPUT

V+

R-

G-

B-

OUTPU T

Input Vo ltage D C 12-24 V

Outpu t Curre nt 5A/C H

Max Pow er 60-1 20W/C H

W-

R-

G-

B-

RF Co de Key

RGBW LED Controller

V+

V-

INPUT

V+

R-

G-

B-

OUTPU T

Input Vo ltage D C 12-24 V

Outpu t Curre nt 5A/C H

Max Pow er 60-1 20W/C H

W-

Summary of content (3 pages)

PAGE 1
RF wireless RGB remote controller Description of buttons SR-2839W ON/OFF For Warm white, Natural white, Cool white changing.(Through the three RGB color mixing) Indicator Color wheel Change red channel Change green channel R G Change blue channel Change white channel B W Save color/scene Save color/scene S1 S2 Brightness Play&pause button. There is 10 build-in modes. Short press it will play, short press again, it will pause. Long press it will speed up/down..
PAGE 2
Operation 1. Do wiring according to connection diagram 2. Learning (matching) a. Do wiring according to connection diagram b. Wake up the remote control by touching ON/OFF button. c. Press learning button on receiver. d. Touch control wheel . e. Connected LED light will blink to confirm matching successfully. f. Press learning button on receiver over 5 seconds until LED light flash, then delete the learned ID. Safety & Warnings 1) The product shall be installed and serviced by a qualified person. 2) IP20.
PAGE 3
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.