User's Manual

ManualsBrandsShenzhen Sunricher Technology ManualsElectronicsRF sender

Table Of Contents

Safety & Warnings

Warranty Agreement

1) The product shall be installed and serviced by a qualified person.

2) IP20.Please avoid the sun and rain. When installed outdoors, please ensure it is mounted in a water proof

enclosure.

3) Always be sure to mount this unit in an area with proper ventilation to avoid overheating.

4) Please check if the output voltage of any LED power supplies used comply with the working voltage of the

product.

5) Never connect any cables while power is on and always assure correct connections to avoid short circuits

before switching on.

7) For update information please consult your supplier.

Please ensure that the cable is secured tightly in the connector

1) We provide lifelong technical assistance with this product:

5-year warranty. We print date on every products, for example :1125 means year 2011,week 25.The

warranty is for free repair or replacement and covers manufacturing faults only.

For faults beyond the 5-year warranty we reserve the right to charge for time and parts.

2) Limited Warrenty

Any defects caused by wrong operation.

Any damages caused by unauthorized removal, maintenance, modifying, incorrect connection and

replacement of chips.

Any damages due to transportation, vibration etc. after purchase.

Any damages caused by earthquake, fire, lightning, pollution and abnormal voltage.

Any damages caused by negligence, inappropriate storing at high temperatures and humidity or near

harmful chemicals.

Product has been updated

3) Repair or replacement as provided under this warranty is the exclusive remedy to the customer.

Operation

Learning (matching)

a. Do wiring according to connection diagram

b. Wake up the remote control by touching ON/OFF button.

c. Press learning button on receiver.

d. Touch any zone button on remote control.

e. Then touch brightness wheel.

f. Connected LED light will blink to confirm zone designation.

g. Press at learning button on receiver over 5 seconds until LED light flash, then delete the learned ID.

Note 1: To choose a master from slaves by jumper for each zone.

Short circuit for master.

Open circuit for slave.

Each zone only can set one master controller. After a period of time, the master will do synchronization

operation to keep the same color or mode of all slaves in one zone.

Note 2: Each remote control 6 zones (areas) receivers, each area can be learned as many receivers as

we can.

Each receiver maximally can be controlled by 8 different remote controllers.

Choose zone number , for example, and , then touch , choose the brightness you want,

zone 1 and 3 will indicate corresponding brightness as we touched.

Brightness Up & Down Button

Long Press button to dim down/up brightness, the dimming direction will change every time after pressing

switch. For example, the first long press is brightness up, it will be dimmed down when long press again.

Brightness level button

Select zone from . Press , the corresponding zones will be 25% brightness. Press , the

corresponding zones will be 50% brightness. Press , the corresponding zones will be 75% brightness.

Press , the corresponding zones will be 100% brightness.

Dim wheel

Save and recall button

select zones from

adjust the color temperature

and brightness

long press one save button

from for 2-3 second

LED lighting flash twice

indicate save successful

a. Save Color temperature:

then short press save button

Recall: select zone button which we want recall from ,