Specifications

3: Sensitive lifting:
The sensitivity of adjustment is recommended to be
fine-tuned by about 10 degree every time, with the
battery moving back and forth adjust the center of
gravity to deal with different flying occasions.
Eg:
In order to increase the speed, the battery moves
In order to increase the speed, the battery moves
forward, the upturned angle is appropriate, the head
angel is reduced and the speed is low.On the
contrary, the speed will be reduced.
2: Aircraft charging:
In order to maintain the performance of the fuselage
lithium battery ,when the power of the aircraft is
insufficient, the flight shall be stoppedand the
aircraft shall be charged in time or replace with a new
battery to avoid using up the power of the lithium
battery
battery
The charging mode:
plug a section of the USB charging cable into the
charging jack, Pay attention to the corresponding slot
position to avoid inserting the opposite direction
causing the damage of electronic devices.Then put the
other end of the USB charging cable into the USB
interface, The red light will be turned on and the
interface, The red light will be turned on and the
charging time is about 45 minutes and please don't
overcharge.When the USB interface light turns off or
blinks,the battery will be full charged.
For better flight results, just do as template fold line,
the last step of the origami aircraft is recommended
to retain a larger wing area. Next, setup the power
section under the paper plane as shown below
standard position:
1
2
3 4
5 6
7 8 9
1: make a paper airplane
Please select a dry new special paper with same
material and size. There are many kinds of paper
aircraft folding,the most common ones shown as
below:
OPERATING INSTRUCTIONS
///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLA
N
/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLA
N
/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPE
R
PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// ///YGD RC PAPER PLAN/// //YGD RC PAPER
Fold paper along the
dotted line at the end,
upturning and ground
horizontal line form
an included angle
of 30 °