User's Manual

32
5.3 Use an external audio system
Right your UMPC has built-audio ports can connect a microphone, and external
speaker, the headphone output jack to record or playback of audio.
1． Audio jack connections:
1. Locate the target device you want to use audio port location (microphone or
headset).
2. Plugs into the UMPC right-hand jack
If you use an external speaker and in the distortion or feedback, please lower the
volume. Sometimes such cases because too close to the microphone and
speaker caused by the external audio devices should be moved further away from
the UMPC, so the situation may be improving.
5.4 Use LAN ports
1. The UMPC equipped with the then-10 Base-T/100Base-TX LAN module,
your UMPC may be through local area network (LAN) and other UMPC or network
connections to support the 10 Mbps transfer rate of up to 100 Mbps. 10Base-T
standard is also known as the twisted-pair Ethernet (Twisted Pair Ethernet), the
use of RJ-45 connectors. 100Base-TX in the old structure is the Ethernet
standard, as compared to 10 times faster Ethernet, also known as Fast Ethernet
(Fast Ethernet).
2. Built-in LAN module provides a standard RJ-45 connector.
3. Twisted-pair will be connected to the LAN port:
4. 1. Requests from UMPC to identify the crates accessories box twisted pair,
each of the two ends of a line RJ-45 connectors.
5. 2. End of the line connecting to the network sockets or hub.
6. 3. To the other side to connect to a UMPC on the RJ-45 LAN ports.
RJ-45 LAN port