User's Manual

3) TURN THE PLAYER AND SPEAKERS ON

Press the POWER ON/OFF button on The Cube speaker

unit to turn the unit on. This will automatically turn the

player on as well. The LEDs on The Cube speaker unit

and player will activate to indicate that power is on.

NOTE: The MP3 player does not require a battery when

it is connected to The Cube speaker unit. The speaker

system will supply power to the player through the USB

connection.

4) MUSIC PLAYBACK

Press the PLAY button on the MP3 player to start

listening to your song files. The LED will start to blink

while in the play mode. If the MP3 player does not

immediately activate after pressing the PLAY button,

please wait several seconds and then press PLAY again.

The MP3 player may need a moment to read the SD card.

It is suggested that you lower the volume to a safe level

before pressing PLAY to prevent any excessive noise that

could damage or harm your hearing.

Volume Setting

Press the VOLUME UP or VOLUME DOWN button to

adjust the volume to your preference.