User's Manual

4
3. Warm light and white light (1:1) 5000-5500K.
Power of wireless charger
(the function is optional)
Maximal 10W.
Material
Aluminium alloy metal support rod and plastic cement base
Adjustable angle for
illuminance
Rotation along 180°
Product size
13.8cm*17.8cm*41cm
Product weight
About 791g
1. Do not look at the light-emitting chip directly because of the strong light here. Looking at the
strong light directly will cause damage to the eyesight!
2. In order to avoid danger of electric shock, please do not dismantle the table lamp and
accessories privately.
3. In order to prolong the service life of the table lamp, it is better to reduce the full load.
4. Keep the table lamp dry. If moisture enters into the table lamp, please stop using it
immediately. Make sure the table lamp is completely dry before reuse.
5. The device with wireless charging function should be placed in the center of the charging signs
of the table lamp in order to obtain the best charging effect.
6. The table lamp heating in the using process is a normal phenomenon.
7. When the table lamp is at its maximum brightness, charging a high-power device will affect the
brightness of the table lamp. So, before charging the high-power device, please turn off or turn
down the brightness of the table lamp.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with Part
Notice