User's Manual

2
green light is on when the table lamp is not charged. During energization, red and green lights are
on alternatively and the green light flickers in case of failure (only limited to the table lamp with
wireless charging function).
④ 50HZ/60HZ-no stroboflash during photographing with mobile phone.
1) On/off key: After the table lamp is POWERED, touch the on/off key for the first time, the red
indicator light is on, and the table lamp is turned on. Touch the key for the second time, the indicator
light is off, and the table lamp is turned off.
2) Mode switching button of Color temperature: When the light is on, touch the M key to switch
the color temperature; the color temperature has three levels: only white light -- only warm light --
ratio between white and warm light is 1:1. Three levels cycle in turn; the color temperatures switch
in time hopping mode.
3) Six-level brightness adjustment key: When the light is on, you can slide or touch the key to adjust
the brightness, and the brightness increases from left to right in turn.
4) In the case of uninterrupted power supply, the table lamp has memory function of brightness and
color temperature.
5) When the color temperatures are switched, the brightness increases in turn from left to right;
when the brightness is adjusted, the color temperature ratio remains unchanged.
(1) Brightness control through 6-key sliding or touching, brightness changes gradually in sequence
of 10% -20%- 40% - 60% - 80% - 100% in turn. When the white light and warm light are on at the
same time, the power is the same as that of the white light alone or warm light alone at maximum
brightness.
(2) The mode switching button of color temperature has an indicator light. Touch the power button,
the color temperature indicator and power indicator will light up simultaneously.
(3) Touch the timing button, the timing indicator light is on and blinking slowly, which means
timing starts. The timing length is 30 minutes. Touch the button again, the indicator light is off and
the the timing function is turned off.
(1) Indicator light for network distribution: Users should note that before WiFi network distribution,
please press the on/off key for five seconds until the WIFI indicator light flashes slowly. It indicates
the reset is completed. At this time, WIFI can be connected.
(2) During network distribution status, the indicator light blinks slowly; after successful network
distribution, the WIFI indicator light is keeping on; Under the network distribution status, the
indicator light flashes slowly and APP flashes slowly under the network distribution status. In case
of overtime network distribution or unsuccessful network distribution, WiFi indicator light is off.
(3) Press the on/off key for five seconds to reset WIFI and then distribute the network again for
Work Mode
Touch Instructions
WIFI Network Distribution (The function is equipped based on the type)