User's Manual

IP DVR SERVER USER MANUAL
29
Vide o Source
Video Source
Choose from Primary Motion JPEG and Secondary Motion JPEG to be
used for FTP, E-mail and/or Event Mode Record.
Frame per Second Configure the frame rate per second.
Condit ion Configura tion
Digital Input
z Recognize the input signal received via Digital Input port as an
event.
z Input: If user wishes to recognize an event when Current State
differs from Normal State, choose ‘Active’ and recognize an event
when Current State and Normal State are identical, choose
‘Inactive.’
z Normal State: Configure if the connected sensor device’s Normal
Stats is Open Circuit or Grounded Circuit.
z Current State: Refer to ‘Input’ and ‘Normal State’ and indicate the
current status of connected sensor device.
Motion
z Digital Motion Setting: Configure the ‘Motion’ area and Sensitivity.
z Continuous motion number for event: If set at ‘3’, event will be
recognized if motion occurs three straight times.
z After motion event, Interval time for motion checking: If set at
‘60’, device will look for new motion after 60 seconds pass from
initial event recognition.
Video Loss
If there is no video incoming signal, ‘Video Loss’ event will be
recognized.
Condition Schedule
All of event conditions will be controlled by condition scheduler. User
can configure when to use and when not to use the event function.