User's Manual

Cautions & Spec.
4
Note1: Some of the 12V DC lighter power sources
will not shut down when the vehicle is turned off.
Please switch off the adapter when you leave the
car, in case the battery of the vehicle is used up.
Note2: Don’t cover the booster body with
anything, in case the power dissipation make the
booster too high temperature. Booster will shut
down when the temperature is too high itself.
Technical specification
www.SolidRFCanada.com 6
Note3
: Use only the power supply provided by
SolidRF, any other products non-approved by
SolidRF or self-made power cable may damage the
booster.
Note4: Troubleshooting
• Properly: The lights on the front panel indicate
the condition of the booster. Every time the
booster is powered on, all of the lights will be
light on in green color for around 2 seconds and
then lights off, this means the booster pass the
self check and in good condition;
• Wrong condition: If any of the lights flashing in
green light, than means the isolation between
the outside antenna and inside antenna is lower
than it should be, and self oscillate occurred.
You must switch off the booster and check the
outside antenna and inside antenna immediately.
Make sure you have followed this installation
recommended, and check every thing carefully.
If you can’t fix the problem please contact the
technician or our distributor.
Frequency
(MHz)
LTE
(band 12)
LTE
(band 13)
Cellular
( band5)
PCS
(band 25/2)
AWS
(band 4)
Uplink 698-716 776-787 824-849 1850-1910 1710-1755
Downlink 728-746 746-757 869-894 1930-1990 2110-2155
Gain Uplink 60±2 60±2 62±2 68±2 68±2
Downlink 60±2 60±2 62±2 68±2 70±2
Output power 23±2dBm(Uplink)/0±2dBm(Downlink)
Noise figure <5dB
In-band Flatness <8dB
Weight 3.5Kg
EIRP 1W
Gain adjustment 30dB
Impedance 50 ohm
Operating temperature -5°~60°
Current ≦2.5A(12V DC)
Dimension(mm) 338*230*35