User's Manual

Overview of installation
1. Select installation location away from direct sunlight, heat, water and proper
ventilation. Do NOT install in a sealed enclosure.
2. Select a location on the roof of the building to install the Outside Antenna. Use a
cell phone in test mode to find the strongest signal from the cell tower. Visit
www.solidrftech.com to find test mode function for your particular cell phone.
3. Run the Outside Antenna cable to the Signal Booster and attach it to the connector
labeled “Outside Antenna” on the Signal Booster. Run the Inside Antenna cable first
to the splitter then to the Signal Booster and attach it to the connector labeled “Inside
Antenna” on the Signal Booster. Lightning Surge Protection is recommended for all
in-building installations.
4. Before powering up the Signal Booster, verify that both the Outside Antenna and the
Inside Antenna are connected and check that all connections are tight.
Note: Be
careful when plugging the connectors in so as not to bend the center pins on the
connectors .
5. The Signal Booster has been packaged with the gain control knobs adjusted to the
highest gain position. If any of the lights are not green, please refer to page 6 – Band
Lights.
Warning: Connecting the Signal Booster directly to a cell phone with use of an adapter
will damage the cell phone and/or the Signal Booster.