User's Manual

3. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal
is detected.
4. If a detected signal is too high in a frequency band, or if the Signal Booster
detects an oscillation, the Signal Booster will automatically turn the power off on
that band.
5. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 times consecutive such automatic
restarts, if the detected oscillation still remains, any problematic bands are
permanently shut off until the Signal Booster has been manually restarted by
reconnecting power supply to the Signal Booster.
6. Noise power, gain, and linearity are maintained by the Signal Booster’s
microprocessor.
This is a CONSUMER device
BEFURE USE ,
you
MUST REGISTER THIS DEVICE
with your wireless provider and
have your provider’s consent .Most wireless provider consent to the use of signal
boosters .Some provider may not consent to the use of this device on their network .If
you are unsure ,contact your provider.
You
MUST
operate this device with approved antenna and cables as specified by the
manufacturer .Antennas
MUST
be installed at least 20cm (8inches) from any person.
You
MUST
cease operating this device immediately if requested by the FCC or a
licensed wireless service provider.
WARNING.
E911 location information may not be provided or may be inaccurate for
calls served by using this device.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device