User's Manual
Table Of Contents
- 1.Introduction
- 2.Product Description
- 3.Indications for Use
- 4. Package Contents
- 5. Features and Benefits
- 6.Specifications
- 7.Operating Procedure
- 7.1 Product indication and key function
- 7.2 OLED screen description
- 7.3 Specific operation method
- 8.Changing the O-Ring
- 9.Attention
- 10.FCC Caution
- 11. Device Label
- 12.Label Symbols Defined
- 13.Prevention of Cross-Contamination
- 14.Troubleshooting
- 15.Manufacturer Warranty, Service and Support
- 16.Magnetic compatibility information
- Guidance and manufacturer´s declaration – electrom
- Guidance and manufacturer´s declaration – electrom
Min I(Smart) User Manual
7
Velocity in different modes
Mode
Flow rate and flow rate accuracy at 1.8ml injection volume
PDL
0.42mL/min，deviation±10%
Slow mode (S)
1.02mL/min，deviation±10%
Fast mode（H）
1.62mL/min，deviation±10%
3 Enter ready state：
Click the Injection mode setting key to change the state of the lock to make
it ready.
4 Start-up：
In the preparation state, touch the Start work key area with fingers to make its
push rod start to work and drain off the air in the needle,at this time, the green
indicator light flashes.
5
Suck-back anesthetic function:
During the injection process, when the finger leaves the area of the Start work
key, the device will automatically suck back.
6 Charging method：
After connecting the adapter to the charging box, put the host computer on the
charging box. The yellow light of the main engine flashes, and the green light
"breathing" on the charging seat is normal charging.To prolong battery life, charge
the battery fully using the supplied charger.
8. Changing the O-Ring
Remove the old O-ring using a dental explorer.Install a new O-ring with a small
amount of silicone lubricant.