User's Manual
Table Of Contents
- 1.Introduction
- 2.Product Description
- 3.Indications for Use
- 4. Package Contents
- 5. Features and Benefits
- 6.Specifications
- 7.Operating Procedure
- 7.1 Product indication and key function
- 7.2 OLED screen description
- 7.3 Specific operation method
- 8.Changing the O-Ring
- 9.Attention
- 10.FCC Caution
- 11. Device Label
- 12.Label Symbols Defined
- 13.Prevention of Cross-Contamination
- 14.Troubleshooting
- 15.Manufacturer Warranty, Service and Support
- 16.Magnetic compatibility information
- Guidance and manufacturer´s declaration – electrom
- Guidance and manufacturer´s declaration – electrom
Min I(Smart) User Manual
10
Symbol for "REFER TO
INSTRUCTION MANUAL"
Product must be collected
separately
BFType Equipment
Caution
Keep dry
Fragile, handle with care
Symbol for
"CONFORMITE
EUROPPENE MARK"
Temperature limit
Federal Communications
Commission
13. Prevention of Cross-Contamination
To help prevent cross-contamination between patients, place a new protective
barrier sheath on the device for each new patient. The barrier must cover the device
and with the cartridge inside and then place the needle through the sheath on the
top of the device connecting it to the boosting pipe.
14. Troubleshooting
1. Before using the suction load function, check the o-ring. The o-ring must be set in
the front part of the plunger. If there are signs of wear, replace it following the
procedure in section V – Changing the O-Ring.
2. When suction loading, the o-ring produces a negative pressure with anesthetic
tube. After a week or every 24 cycles, apply a small amount of silicone lubricant to
the o-ring.
3. If there is ever a system halt, put the handpiece on the charging seat. The
handpiece will automatically reset to the original settings.
15. Manufacturer Warranty, Service and Support
The Mini I(Smart I) Electric Oral Anesthesia Injector is guaranteed against
manufacturer defects for 1 year from date of purchase. Do not attempt to
disassemble or repair the handpiece – it contains no user-serviceable parts.
Contact us for a Return Manufacturer Authorization(RMA) and shipping instructions
in advance.