Users Manual Part 2

3D Printing
54
|
Quick Start Guide
|
55
The nozzle and the heated bed are still extremely hot right after printing.
Share!
Youcan share your prints
in our Facebook group and
our forum.
3.3.2 Start Your First Print
Guides & Pictures / Snapmaker
3.3.3 Remove the Print
Guides & Pictures / Snapmaker
After receiving the G-code file, tap Yes
and Start on the touchscreen to start
printing.
Wait for the temperatures of the nozzle and the heated bed to drop to room temperature (displayed on the
touchscreen) . Remove the print sheet from the heated bed and bend it slightly.
If you need to adjust
settings, you can either
tap Adjust Settings
prior to printing or swipe
left on the printing
progress screen.
If you run into the issue of poor adhesion, swipe left on the printing progress screen and you can try adjusting
the Z Offset. Or you can try leveling the heated bed again by selecting Calibration. Make sure the tip of the
nozzle is clean before you calibrate the bed.
Remove the print sheet from the heated bed, place it down on a stable and flat surface. You can
also use the palette knife to remove the print.
The palette knife is sharp.