Manualshelf

Users Manual Part 2

ManualsBrandsShenzhen Snapmaker Technologies ManualsElectronics1600mW Laser Cutting Module
12345678910
3D Printing
50
|
Quick Start Guide
|
51
You can change the target Nozzle Temp by sliding the scale bar.
3.2.2 Load Filament
Guides & Pictures / Snapmaker
How It Works: Filament Loading
The motor drives the filament into the extruder, then the filament extrudes through the nozzle after being
heated by the heated block.
How to Load Filament
1.
Hang the provided PLA filament over the filament holder. Cut the bending end of the filament using the
diagonal pliers, then insert the filament into the 3D printing module.
2.
Tap Start on the Load Filament screen. After the temperature reaches the target temperature, tap Load and
then gently push the filament into the 3D printing module until you can feel the motor pulling the filament in.
3.
Clean the nozzle using the tweezer, then tap Done.
If there is no filament coming out of the nozzle, do not tap
Done
until you repeat the steps
above and the filament extrudes successfully.