Users Manual Part 2

3D Printing
46
|
Quick Start Guide
|
47
It is recommended to wait for 5 seconds when you turn your machine off and on again.
Make sure there is enough cable length
for the toolhead for movement.
Please skip this step if you
have completed the initial
setup.If youneedtochange
the settings above, swipe
left on the home page of
the touchscreen -> select
Settings -> tap Wi-Fi or
About Machine as needed.
The initial guide, which
helps you get started, will
appear only once. If you
need to launch it again,
swipe left on the homepage
of the touchscreen -> select
Settings ->tap Guides .
07
/07
Attach the Cable Holder to the Z axis, then lock the Toolhead Cable into place.
3.1.2 Initial Setup
Guides & Pictures / Snapmaker
Plug the AC Power Cable into an electrical outlet. Switch the power on and follow the prompts on the
touchscreen: Read the Terms -> Name the Machine -> Connect to a Wi-Fi Network.
Cable Holder x 1
M4 x 8 Screw x 2